DropThatHammer

Hello everyone and thanks for looking.
I almost have my transmission out on my IX MR. I can't seem to get it out. The TOB is released and everything, but it just won't release it self too far from the block.
Any help appreciated and if anyone would like to stop by and help I will pay for their time, troubles. I live in Hacienda Heights.
562-587-4808
-Jimmy

stevelubs

figure it out?

sourtowel

iTrader: (7)

I'm having the same issue. I am going to attempt to take apart the clutch assembly through the inspection cover.

meric

iTrader: (1)

I have read about this before and everyone takes the clutch off threw inspection cover when this happens. Make sure to check for any hung up bolts and what not. Trans not hitting anything

detroit pistins

iTrader: (102)

Did u guys try popping it out with a flat head? give it a try and see what happens. Attached are the instructions. # 47

http://www.evomoto.com/tech_articles..._article_id=27

Roadrunr

iTrader: (24)

Did you remove the axle shaft [ stub shaft ] that goes through the transmission and into the transfer case?

Just noticed this is an old thread LOL