Guys what the hell did I do besides f*** up bad. My antenna looks like it's in the middle of the bracket for the VG, but for some reason I can not get this thing to line up at the edges.

Is this thing supposed to hook into any plastic clips? I know you have to position the plastic clip in the middle of the VG and I did that

Any help would be appreciated.

 

I think you're supposed to put it under the weather stripping. But I'm sure someone on here knows.

 

Where did you buy that.

 

if your talking about the drip protection (black rubber strip) I did put it under that as you can see. What exactly do you mean?

 

It's from a dealer OEM stuff that's why it's has to be me, unless it was packaged wrong to fool me

 

Might be wish I could help more.

 

u have to lift the blach w strip, install it vg then reinstall the w strip

 

My OEM has real small gaps where yours does....but not that much.

 

I know and I did do that. It seems like the VG is not wide enough

 

remove black strip like previous person said....line up and install generator correctly...fasten...and reinstall black strip...making sure it's clicked in nicely....they do come off at high speeds if not fastened

 

what do you mean by fasten after you say "line up and install generator correctly"?

 

step 1. apply 3m double sided tape to vortex generator
step 2. detach black weather stripping the runs along roof of evo/reg lancer
step 3. place generator on roof where you feel it looks good and straight
step 4. press down firmly on generator so a nice bond is formed with room/3m tape/ and generator
step 5. reattach black weather strip and click firmly in place

drive off @ 100+ mph and feel the generator ...generate lol

 

that's what I did the 1st time except for the driving part

 

what does the other side look like...looks like more on one side than the other

 

The 2 pic's above are of different sides. They both look the same to me.