SRT4 TD04 in Lancer?
Thread Starter
Joined: Feb 2005
Posts: 2,914
Likes: 0
From: Central TX, Houston, and Huntville, TX
SRT4 TD04 in Lancer?
Hey, I searched for this and only found it mentioned in the ralliart section. If I were to go custom turbo setup, I could basically use whatever turbo I wanted right? I have a friend with an SRT4 and he swapped his turbo out for the same one, just ported, and I was wondering if I would be able to use his stock turbo in a custom setup. It is a TD04LR I believe. Or would that just not be a good turbo to go with.
It should work fine. As you kind of implied, anything will fit as long as you design for it.
FWIW, I know the WRXs also use the TD04. They're most effecient when water and oil cooled, so try to be aware of that.
FWIW, I know the WRXs also use the TD04. They're most effecient when water and oil cooled, so try to be aware of that.
Thread Starter
Joined: Feb 2005
Posts: 2,914
Likes: 0
From: Central TX, Houston, and Huntville, TX
yeah ive seen the wrx TD04 as well when searching. I couldn't find the difference though because I think the WRX is a TD04L and the SRT4 is a TD04LR. But yeah it would be custom so I figured it would fit. Thanks
I don't know if it will work, the R stands for reverse rotation like the evo turbo. Not only that but the SRT-4 turbo has its hotside and exhaust mani. cast as a single piece, correct me if I'm wrong, I think I read that in SCC when it first came out.
Thread Starter
Joined: Feb 2005
Posts: 2,914
Likes: 0
From: Central TX, Houston, and Huntville, TX
yeah i saw that as well which was worrying me. This is the manifold. Doesn't look like it will work

But OBX makes a manifold for that car that looks like a normal one.

So I'm confused, but my buddy has the turbo so I can look at it in person before I buy it. If not, I'll just find something else.
But OBX makes a manifold for that car that looks like a normal one.

So I'm confused, but my buddy has the turbo so I can look at it in person before I buy it. If not, I'll just find something else.
Trending Topics
I plan on using my stock turbo off my wrx. So sometime over the winter ill start the build.
Im geeting my manifold supplys from these 2 sites.
they have the head flange for a 4G93 Mitsubishi. that will work on our 4G94 right??
http://bmcrace.com/products/flanges/
http://www.acestainless.com/
Im geeting my manifold supplys from these 2 sites.
they have the head flange for a 4G93 Mitsubishi. that will work on our 4G94 right??
http://bmcrace.com/products/flanges/
http://www.acestainless.com/
Thread
Thread Starter
Forum
Replies
Last Post
bnice01
Evo Engine / Turbo / Drivetrain
5
Aug 11, 2007 04:20 PM







