Getting the Lancer Tuned?
Thread Starter
Evolved Member
Joined: Aug 2007
Posts: 633
Likes: 0
From: DC
Getting the Lancer Tuned?
I have been slappin on the mods and now its time for some fine tuning. Whats the current procedure for getting this thing dialed in to perfection.
Im on the East Coast, but im looking for input everyone can use. I already have the Works Flash but would like to take it a step further and have it tweaked locally.
Im on the East Coast, but im looking for input everyone can use. I already have the Works Flash but would like to take it a step further and have it tweaked locally.
Evolving Member
Joined: May 2008
Posts: 362
Likes: 0
From: Youngstown, OH
Trending Topics
Evolving Member
Joined: Aug 2007
Posts: 169
Likes: 0
From: New York
Evolving Member
Joined: May 2008
Posts: 362
Likes: 0
From: Youngstown, OH
From the dnyo sheets in the WORKS Flash thread on this forum, flash alone gives you 16-17hp, 13 TQ, combined with the header would probably be well over 20-22hp. The header is rated for 8hp but I don't know how it would add up with the flash. Dont forget about torque
.
.Here's an updated graph.
Sorry the graph points aren't marked for the before run, the box in green is actually just a lower point along the power curve of one of our "flashed" runs. But if you ignore the numbers in the box and look at the graph itself you'll see power gains of around 17 horsepower and on the torque side its around 13 lb/ft.
-Bill@WORKS
Sorry the graph points aren't marked for the before run, the box in green is actually just a lower point along the power curve of one of our "flashed" runs. But if you ignore the numbers in the box and look at the graph itself you'll see power gains of around 17 horsepower and on the torque side its around 13 lb/ft.
-Bill@WORKS
Last edited by Bawb3; Sep 10, 2008 at 05:41 PM.
