Hello, has someone install the HFS-5 V10 on the evo 8, i need i help with the setup, please help.

 

This is stickied at the top of this section. It is a great start...http://scheides.com/misc/pics/evo/Ho...ll%20HFS-5.pdf

 

the link is broke, it's for the V10?

 

On the fifth page there is a second link that scheides put up. It will work for the v10. All you should have to do is click on the url in my post.

 

Thanks for your help but i can't find the link you'r talking about, on the fifth page is the HSV Assembly and the follow page has the follow lnks:

You will need to purchase your own tank for the install; it is recommended by Aquamist
that you purchase one from http://fluids.flambeau.com/
Tank info –
4 quart tanks: part #062600
http://fluids.flambeau.com/multipurp...4.0_quart.html
https://www.evolutionm.net/forums/sh...d.php?t=277831
5 quart tanks: part #062100
http://fluids.flambeau.com/multipurp...5.0_quart.html
http://www.putfile.com/pic.php?img=4802806
https://www.evolutionm.net/forums/sh...7&postcount=13
6 quart tanks: part #062150
http://fluids.flambeau.com/multipurp...6.0_quart.html
https://www.evolutionm.net/forums/sh...24&postcount=2
https://www.evolutionm.net/forums/sh...d.php?t=263787

 

Click on the link in this post.... For me it is a pdf that shows the basic install. Start on page 8 to jump to were to run wires and ideas of where to place components.

Buy your tank from WWW.howertonengineering.com

 

I have found the correct diagram for the V10/EVO8

 

^ Thanks Richard! I did not know what he was asking for exactly. I hope that helps. I also edited my previous post. Where to run wires/etc. starts on page 8.

 

I have just realised that I have never published the DDS3v10 to EVO 8 diagram before. Thanks for chiming in to help, much appreciated.

Richard

 

Thanks Richard, I never seen that diagram, do you have the diagram with the electronic boost controller (blitz) and fail safe?

Thanks a lot

 

I think this diagram should work with your Blitz EBC.

 

Richard the blitz boost controller doesn't have to be connected to pin 6 and 7? 8, 9 y 10 is not for the fail safe?? is what I understand on the manual, please help me with the fail safe setup

Thanks.

 

You don't need to connect the blitz to 6 and 7. It is intended for an alternative BCV usage.

Just follow the diagram above:

1. Gauge off: Blitz off
2. Gauge on: Blitz on
3. Gauge on + on boost: Blitz on
4. Gauge on + on boost + no flow: Blitz off

 

thankkkkkkkkkkk for the info