USDM Evo 9 ECU pinout here
#16
Evolving Member
Join Date: Dec 2005
Location: South Africa
Posts: 232
Likes: 0
Received 0 Likes
on
0 Posts
Hey all,
I see in the above link from mrfred that pin 23 is 5v unknown load, has anyone tried to use it yet for a MAP sensor, as this would be so much easier than splicing into pin 42 for power.
also what changes in evoscan are needed.
thanks
Mike
I see in the above link from mrfred that pin 23 is 5v unknown load, has anyone tried to use it yet for a MAP sensor, as this would be so much easier than splicing into pin 42 for power.
also what changes in evoscan are needed.
thanks
Mike
#17
EvoM Guru
iTrader: (1)
bump, zip file does not work on both of my computers, followed this link from the wbo2 thread, and Im looking for where to connect the analog out from my AEM > evo ecu
http://evoecu.logic.net/wiki/USDM_IX_ECU_Pinout
Incase it comes up again
http://evoecu.logic.net/wiki/USDM_IX_ECU_Pinout
Incase it comes up again
Last edited by 211Ratsbud; Feb 15, 2011 at 09:15 AM.
#20
Account Disabled
iTrader: (1)
bump, zip file does not work on both of my computers, followed this link from the wbo2 thread, and Im looking for where to connect the analog out from my AEM > evo ecu
http://evoecu.logic.net/wiki/USDM_IX_ECU_Pinout
Incase it comes up again
http://evoecu.logic.net/wiki/USDM_IX_ECU_Pinout
Incase it comes up again
Thread
Thread Starter
Forum
Replies
Last Post