Thanks Joe just downloaded that to my Palm/phone.

Anyone know what is different between these two parts? From searches, it appears the latter is the metal MR BOV...assuming bypass valve isn't another term for wastegate valve.

 

I was on the mitsubishi site and they list a "front strut bar" as an option, anybody know if this is a better (stiffer?) version of the one that comes stock? what is the part #?

-joe

 

Hey, guys, I'm wondering if anyone got part number for:

'05 EVO MR Silver

Right (Passenger Side) Front Fender
Right (Passenger Side) Complete Entire Light (Including Housing, HID)
Right (Passenger Side) Front Wheel well Plastic Dirt covering
Hood

Long story short, something fell out of a truck, and hit my right side, on 91FWY. I pulled over, but the truck left.

 

All parts are listed in bold above. I'm sorry to hear of your accident. Good luck getting the repairs taken care of.

 

Thank You! You've been a great help!

 

I am looking for a part number, if it even exists, for a pig tail connection for the rear O2 sensor. I am looking for the O2 sensor side so I can completely disconnect the O2 sensor and plug in the pig tail, which will be wired to the O2 eliminator. If this exists, please let me know what the part number is. Thanks.

 

I didn't get any bolts with my RS trunk bar, can somebody get the part # for the bolts needed to mount it?

also I just broke 3 out of 4 of those little fastener things that hold the plastic trunk trim (the one with the latch in the middle), can somebody get the part # for them too?

thanks a lot

-joe

 

Cannot get the pigtail alone. You'll have to buy the whole floor harness. MN124356

 

Bolts: MS240129
Clips: MR572500

 

thanks

 

They are 8m-1.25 bolts about an inch or so long. I just grabbed some out of my misc. bolt bin.
I use socket head bolts on the trunk bar that I make.

 

Thanks for finding the floor harness part #, but I may be a bit confused, or maybe you are.

I am looking for the pig tail that plugs into the harness. It would actually be the O2 sensor side of the harness. If I have to buy a whole new rear O2 sensor just to get the connection, then that would be what I am looking for. Thanks in advance.

 

Ahh, I read you're post a little too quickly. The pigtails for that are also not avail. from Mitsu (I'm attempting to locate the OEM supplier/part # but that'll have to wait until I'm back home)

In any case, as posted above the rear O2 sensor PN# MR578532

 

Thanks for the check. If you do find the pigtail/harness connection, please post it here, or pm me as I plan on making up several O2 elims that will be a direct plug in. I also plan on posting a how to on it referencing the correct part #/location to buy it at.

 

I just wanted to clarify with you. So the '05 o2 housings are the same as the '03-'04s right?