Evolved Member
Quote:
Originally Posted by Excalibur
Outside coated only, or in and out?
personally, i wouldnt incase it cracked off and went into my turbo, but it has been done, i dont see how it would help since its already insulated from the outside...cost isnt worth it either
Newbie
I think you can get the Hallman Pro RX boost controllers for around 100 bucks now. Great controller for the price.
Quote:
Others can be had for half that and are just as good. If you want to adjust boost in the cabin, do ECU controlled boost Originally Posted by RaiN907
I think you can get the Hallman Pro RX boost controllers for around 100 bucks now. Great controller for the price.
You're just asking for one of your friends to just crank it randomly when you're not looking!Quote:
top or bottom?
On top. Whatever makes the top travel the least while rotating around the center ball section.Originally Posted by joon82
on short shifter which way is more aggressive?top or bottom?
Evolving Member
Just installed short shifter from ebay($35 shipped) with the bushing that came with it.
I tried to do it aggressively but didnt have proper tool to cut the portion of base. So I went with less aggressive. It definately feels shorter than stock and also smoother than stock.
I wonder how it will feel when I switch to aggressive.
Top cover didnt fit right after installing aluminum bushing that came with shifter. Had to remove large washing and the problem was solved.
Best $35 I've spent so far on my evo.
Also it only takes about 20-30 min(it was my first time too)
btw you'll need tool to cut stock shifter if not u have to get replacement from mitsubishi.
I tried to do it aggressively but didnt have proper tool to cut the portion of base. So I went with less aggressive. It definately feels shorter than stock and also smoother than stock.
I wonder how it will feel when I switch to aggressive.
Top cover didnt fit right after installing aluminum bushing that came with shifter. Had to remove large washing and the problem was solved.
Best $35 I've spent so far on my evo.
Also it only takes about 20-30 min(it was my first time too)
btw you'll need tool to cut stock shifter if not u have to get replacement from mitsubishi.
Evolved Member
i just got the ets lp2 licp and the rs trunk bar... bad *** thread!!
Evolving Member
Great thread...I was content to not mod for awhile and then I ran across your thread and DAMN YOU! I'm modding $100 bucks at a time, but it's turning out to be too many times a day. Just picked up the SS kit, speed source under hood bushings, and Rotorpro rotors. Now I need to breathe and start again next pay check.
Mike
Mike