Mechanical o2 Fix
1. You will pass inspection.
2. You don't need 2 anti-foulers. If you drill the hole to 17/32, the space between the tip of the sensor and wall of the anti-fouler is so close that the fumes cant get to the element.
The hardest part is centering the hole perfectly so the sensor screws in.
I have a few of these already machined if someone is looking for one..
2. You don't need 2 anti-foulers. If you drill the hole to 17/32, the space between the tip of the sensor and wall of the anti-fouler is so close that the fumes cant get to the element.
The hardest part is centering the hole perfectly so the sensor screws in.
I have a few of these already machined if someone is looking for one..
Last edited by EVO8emUp; Nov 1, 2007 at 01:57 PM.
Newbie
Joined: Jul 2006
Posts: 15
Likes: 0
i think i have to put 3 adapters because mine still "service engine soon" light on... and right now have two adapters..!! i need some help.. my RALLIART have INJEN, DOWNPIPE(custom), RRM PULLEY.... i have these codes on the scanner: "system too lean", and something about o2 sensor.... PLEASE!!! my car after installing the aftermarkets run worst than STOCK!!!! (dyno)
Stock: 149hp and 154tq
downpipe, injen, pulley: 150hp and 144tq
Stock: 149hp and 154tq
downpipe, injen, pulley: 150hp and 144tq
Newbie
Joined: Aug 2007
Posts: 85
Likes: 0
From: NJ
o2 fix works great got my car in 2007 i put Road///Race Race Series Header/Downpipe, ROAD///RACE Ralliart Underdrive Pulley Kit, ROAD/RACE - Magnaflow Highflow Cat, ROAD/RACE MIVEC Engine Ported/Polished Intake Manifold, ROAD/RACE Piggy Back ECU Automatic Version 2 and cai all of this stuff run good
Works for me, I used both antifoulers, put 600 km on and no CEL. Did not have problems with clearance since the angle of the sensor was parallel to the ground. 
for custom mandrel bent exhaust system =)
for custom mandrel bent exhaust system =)
http://www.streettunedmotorsports.co...engine_fix.htm
just ordered this w/ a test pipe last wk. Hope it works!
just ordered this w/ a test pipe last wk. Hope it works!
Apparently you can get one of these brass fittings from hardware stores, for cases in which your antifoulers make the o2 hit the body.
Fix provided by whtevo
I asked him where he got the fitting and he cant remember. If I get one, I will post it.
see bottom of page24 of
https://www.evolutionm.net/forums/sh...&page=24&pp=15
Fix provided by whtevo
I asked him where he got the fitting and he cant remember. If I get one, I will post it.
see bottom of page24 of
https://www.evolutionm.net/forums/sh...&page=24&pp=15
