How to make cheap coil on plug setup
Where are you guys finding these with pigtails? I can't find them anywhere....
-> Sloppy Hachi
That's a rad looking set-up! What kinda gap can you run on the RSX coils?
It also looks like you're leaving 10-15whp on the table with the TB elbow up there...
That's a rad looking set-up! What kinda gap can you run on the RSX coils?
It also looks like you're leaving 10-15whp on the table with the TB elbow up there...
Thanks guys. Nimpoc, yea I know that elbow is killing me I'm just trying to figure out how to make a smooth bend cause the piping is so big. As far as a gap goes I'm running .20. Cars been running very smooth despite the fact that it needs to be retuned. As far as finding the pigtails we've just been going to junkyards and making sure the pins on the tails match the pins on the coils and A + B = C. Any ideas on how to re-route that bend off the TB?
Thanks guys. Nimpoc, yea I know that elbow is killing me I'm just trying to figure out how to make a smooth bend cause the piping is so big. As far as a gap goes I'm running .20. Cars been running very smooth despite the fact that it needs to be retuned. As far as finding the pigtails we've just been going to junkyards and making sure the pins on the tails match the pins on the coils and A + B = C. Any ideas on how to re-route that bend off the TB?
By the way your cop looks boss!.
Hi everyon sorry for the delay i just found what the problem was first the tankgas had water i dont know how but it fix second problem that i need to do was to close the gap on the spark plugs to 25 i ran the car and at wot everything was extremely fine it run better idle better these is a AAA++++ good job man
Joined: Oct 2011
Posts: 342
Likes: 8
From: Detroit metro area Michigan/Washington DC metro area
don't ask about the wood we are using it as a templete, came out well though, are any of you using any kind of CDI with the set up every now and then i get a Random misfire on cold starts ?
Newbie
Joined: Apr 2011
Posts: 28
Likes: 0
From: Granite Falls, WA
brilliant write up I was looking for a cheaper way to do this I knew there was one but couldn't figure it out. Now just to make time to get to the wrecking yard and pick me up a set of these babies!!
coil on plug
What I would like to know though is which type to use with this 4-coil setup, the dis-2 or dis-4.
Question: if I use the yaris/ Toyota coils (90919-02240) that fit under the cover, do I still need to make a plate to mount these or are you guys just using the cover to keep them down?
Nevermind...answered my own question
Nevermind...answered my own question
Last edited by evoix10; Nov 28, 2012 at 04:54 PM.
Newbie
Joined: Mar 2012
Posts: 92
Likes: 0
From: miami
Where can I get the carbon cover?
