I've never used EvoScan so I really can't comment. Are looking for a sampling rate?

If it would help, I could post up a log I took the other day and you could maybe take a look at it using a trial version of PCMScan (I'm assuming it will let you.)

Here's a list of the supported PID's:

 

The Tactrix 2.0 cable works without any other hardware.

 

I'm using an OP 2.0 cable, so yes.

 

Realized my reply wasn't as helpful as it could have been...

I'm looking at the list of PIDs and it shows listings for the AEM, Innovate LM-1, TechEdge, and Zeitronix wide bands.

 

I have been using this
the logger is a bit slow and really doesn't support many PID for evo X
it "gets the job done"

 

i use the Innovate OpenTune OBD-II / CAN Interface OT-1. it has it's own obd2 port cable and works on most if not all odb2 cars. i use the OT-1 along with the Innovate LC-1 and Logworks (which is free from Innovate). sample rate for the Evo X is very fast.

http://www.innovatemotorsports.com/products/ot1.php

 

I have a little problem with 1.41 on a JDM EVO X with this ROM 52350016 , I was able to read ECU one time , file looks OK, but couldnt write it (sending init........no response for any known code), after this I cant read file again the same error, Openport works OK in EVO 9, drivers reinstaled, everything looks OK, any ideas ?

 

Have you tried with fresh install of windows or with other laptop that never had ecuflash/evoscan installed?

 

I am using the same ROM but does not encounter this problem. Tried on 2 Evo X and still ok! The only time I encountered error is after I loaded a Rom I need to off and on the ignition in order for the flash to be successful.

 

Help pls with xml-files. I have 3 EvoX roms (hex-files)
-EDM GSR 5MT ID 53040007
-RS 5MT ID 53040007
-EDM GSR SST ID 53050006.

I tried to create xml from other xml-files, which are at the ''rommerdata" directory, but don't receive correct result.
I can sent mail with my hex-files if it is necessary.

 

Gunzo already working on it

 

Interesting. So you can use your Logworks data in Data Log Lab? Are you able to log knock?

 

OT-1 is generic OBD2, just like PCMscan

My OT-1 is a door stop that has never worked correctly, YMMV.

PCMscan is $50 cheaper and less hardware to use (OpenPort 2.0 works with it)

 

wut version of pscmscan are you guys using? i cant make mine work for the evo....

 

PCMScan v2.4.10 (Build 977)