I am getting the SSS spoiler soon. Can anyone tell me what they used to drill the whole and the bit size?

 

I used 4 holes in all in GSR to fit the SSS tall spoiler and its fine

 

can you show me the 4 holes that were used and what you used to drill the extra holes

 

you need to do just one hole inside the trunk has the mark where.

I don't do the hole under the cap and is just fine.

the placement of the poinst for installation are the same just one needs to be drilled and as i said before the one under the cape needs like a grommet with thread to install the screw so i dont do it.

 

I've been looking at how to improve my stock GSR wing for awhile now and I haven't been able to locate anything solid. The one upgrade that I've seen that I could potentially benefit from is the AMS Wickerbill that they made for Ryan on his X. I attached a photo of it below, I hope Ryan won't mind me linking his pics.



I've contacted AMS around a week ago but I still haven't gotten a response.

 

What size drill bit?

 

Do you have any finished photos?

The GTS actually looks close enough to the X and RA that I regularly get them confused when driving. I bet the wing looks nice on it. I'm enjoying the stealth wingless look myself, so I guess I'm trying to make my Evo into a GTS . Take it easy .

 

do we really need all 3 on each side or can i get away with just the two on each side

 

Hey guys, Does anyone know where to buy oem tall wing blue?
I would trade my oem wing as well

 

well i just got my high wing installed. we used all three screws on both sides, becasue at speeds of 140mph plus im not sure if i trust just two bolts, looks great, install was pretty easy too.

 

Anyone have any more advice on the install? Most of the pics are dead and there doesn't seem to be a lot of detailed information (drill bit size, hardware needed, what to remove, etc). I am going from an SE deck lid with no holes to a SSS tall wing.