stock axles/transfer case/driveshaft/rearend but after 600awhp I put in the buschur tranny

 

Your running out of time to run that 9. You should be able to do it!

 

I ran out of luck, the engine is making some noise so I'm pulling it apart. My guy said the valvetrain and rod bearings look good so we suspect a piston/wrist pin but won't know until we get it all torn down. I'm surprised it lasted as long as it did after what I put it through daily haha.

 

Good luck bro ...

 

any update?

 

ended up being the wrist pin, boxing it up and sending it off to be fixed soon

 

No more updates?

 

the engine is out but I'm working on some higher priorities right now so it may be some time before I get it back up and running.

 

Sucks Chris. I wasn't aware it popped.

 

yeah it was a bummer but luckily it didn't scatter and throw parts, it just started making a light scraping noise while cruising back to work from lunch one day so I shut it down. I guess the years of daily abuse finally weakened the internals.

 

Did you figure out what the problem was yet?

Sucks for the failure, but stuff happens. Good luck on the rebuild.

 

lol i just read the first page and this page. It's nice to see where everything starts

 

one of the wrist pins had a crack

 

What caused the engine to pop?


Sean

 

chris any news bro ? :S