I'll email tephra to be sure for you guys see if there was anything i'm missing here

 

Okay on the maf scaling i notice a few values that i cant copy over from the eclipse rom to the lancer rom.



The lancer table is on the right for scaling and smoothing. Is there a way i can change the load values to match the eclipse roms also how do i increase the values on the right by .xx instead of increments of 1.

 

The scaling is different.

Also it appears that the left hand column isn't located to the correct address.

 

So how can I fix this, do I need to find my Own values, or should I go back to the evo rom.

 

Right click the table and see what the scaling is and make them both the same. You could use unit8 if you can't find one scaling or the other.

As for the left hand column I'd just leave it alone probably doesn't have the right address in there anyways.

 

what if one tablegoes to 7000rpm and the one on the lancer rom only goes to 5250. Do i need to find the values on my own, like just keep trying it until i find what works best??

 

Obviously a direct copy wont work if the scaling is different as the values where the scale equals the same wont match up. I'm assuming this has something to do with fuel or timing?

 

okay i think i got pretty much everything worked out for the most part, only thing i notice is that my rpms drop a little slowly after i go from say a 3rd gear pull to coasting in nuetral.,

 

Update.

Confirmed that the rom itself doesn't have a way to disable cranking enrichment thanks to tephra and mrfred. I also noticed when comparing it to another rom that my definition for cranking ipw enrichment is likely wrong.

I'm going to get a new xml out here soon fixing the cranking enrichment

 

Awesome!

RS, if I disable the EGR through periphery will it be okay if I leave the valve and all the hoses attached?

 

Should be fine it just disables the test. The activator portion is different its deactivated by setting the bit to 0. I'm pretty sure i don't have it defined for you guys.

 

Here's an xml to try

 

Hey RS hopefully you will know, in the tephra V7 rom I am using the accel enrichment also says (incorrect) so I cant adjust the enrichment in this rom?

 

There are other tables to adjust that just don't use that one

 

awesome so what changes did you make to this cause i see its slightly bigger