Hi all
im installing a few gauges in my car
and was wondering where everyone
else ran their wiring thru the fire wall
any place easier than another?

 

Run a search next time!

There's a plastic boot that you can drill through on the driver's side. You can follow the hood relase cable to find it, or better yet check my registry cuz I have a pic of it. The wiring will run inside the driver's side front quarter panel.

 

thanks captain

 

you can do that or go thru the pass side takes a bit more wire but easier 2 get 2

 

Do it this way:
Take off the stuff around your wheel well, then youll see a rubber grommit near the door, lift a corner of that up and put the wire through it. Dont take the rubber piece out cuz its hard to get back in.

 

I ran mine through the driver's side fender, then through the rubber hose that connects the door to the body. Here is the how-to posted in the Audio section.
https://www.evolutionm.net/forums/sh...threadid=26905
This is only good for 1 wire though.

 

or just go thru the steering boot. thats how my boost gauge is ran.

 

i have a decent amount of wire run through the hole in the passanger side its in the corner its a good 3/4 or inch wide what i did was put some loom though the hole and i runn all my wires through it its simple then you can run the wires where u need them