so i got my wheels today, 18x10.5 RPF1's +15 for the front, 18x10 +38 in the rear

 

Nice rims!

evobeatsti, you coming out to the SFR region divisionals?

 

i dont think so, but i think i will be moving out to california in sept of next year so i will make all the events then

 

Yowza, thought you were doing NTO3s!! Hope for no spoke flex on the RPFs! Love the sizes...

 

i was going to do the NT03+M's but they didnt have a low enough offset for my fenders. also the RPF1's weigh less and i think at speeds below 60mph, i wont have to worry about spoke flex. Plus i have always loved the way these wheels looked and i got them for a killer deal ($250 for the 10.5's and $23x.00 for the 10's)

 

Yes, they do weigh less, and I would have gotten them if not for the expected track usage. I thought you were looking to start doing time trials, though.

 

yah but not on these, i am not going to destroy a set of A6's for some laps, i think i am just going to start off using some 235 ra1's on my stock wheels then move up from there

 

That'll work, or rather, use good street tires on the stock rims. RE-01Rs or something...

 

yah the thing is i found a set of used ra1's for like $200 for the set so i was just going to buy those until they die then just get some 18x9.5's and put some take off slicks on them or something

 

Jeez, neverending money pot.

 

lol, i most likely wont be getting those 18x9.5's unless my friends who have evos will get rid of them which is likely. trust me Clayton, i am pretty good at finding good deals

 

Where'd you get the RPFs? I'm looking to get 17x9.5s in 38mm offsets, like the NT03s I have...

 

i got 2 of them from a shop in florida called import image racing, their # is (239) 540-6385 they were real good to work with, here is there website http://importimageonline.com/contact...8234a4cfb87c03
the 18x10's i got at my local discount tire, i have a friend that works there that gives me good prices.
if you are buying new wheels go up a size! at least get 17x10's haha

 

ok, everyone with harnesses (jarrod) where did you mount them? i got the takata long harnesses and bolted the back part to where the rear seatbelts used to be, but where did you bolt the lap part into? did you use the stock seatbelt location or did you drill the floor board or did you put it in the seat mounting bracket? thanks

 

I used the stock front locations. If you get the right size bolts and washers and spacers you can keep the stock front belts for tooling around town. . .