jeeez and i thought i was a thrift shopper and your over here cutting up the rag bin for an air box hahahah

 

I'll tell people i "3D printed it" lol
btw my "rag bin" is a cardboard box

 

Well that makes sense being cardboard as it looks like no plastic box is safe from a sabre saw in your shed hahaha

 

you have a point. I'm a hack


rock shield

 

It aint dumb if it works haha

 

room for essentials

 

more bottom cover shenanigans. still have to trim them because they will hit my driveway

 

Maybe I missed it, is your splitter attached to a stock undertray?

The deflectors for brake air look good there.

 

I dont have a splitter. just looking to have some alternative to the 2" hose brake cooling. maybe later I can get the flaps closer to the hub (and into a shroud). obviously I have to remove these for autox.

 

We make a TON of heat in AutoX, especially at some sites that are longer and higher speed. My solution Im working on is a PVC duct for my leaf blower I can turn a dial to keep on. 1 inlet for the blower, then 3 outlets for oil cooler and left/right wheels. I can get the tires cool between runs but the wheels and brakes themselves get scorching hot.

 

seems like a distraction getting your head ready for the next run. maybe you can work with duct fans? these used to be super cheap. very light, and I put 1 on each front rotor heat shield on my A4. My car sounded like KITT

 

We already have a ton of work between runs with getting tires and temps under control plus driver/number change over. So sliding in a duct would be potentially easier and more effective.

 

I see. not as hectic as OPR shaving atleast. thats the craziest I've ever seen in-between runs. you need the whole gang lol

 

what kind of PVC parts?

 

Im sure ViciousLSD has some old dunny pipes or maybe he can cut down some of his guttering on his shed and sort ya out there Dallas hahaha. He might have some left over parts bins he can chop up as an intake scoop for it too