Project X - Water/Meth Install!
#63
well the tanks should being posted today/tomorrow from the states
Then once I get them I just need to plot out the holes on my bracket...
still need to finalise the thickness of the bracket... im thinking 3mm, but really need to engineer it properly
yeh its taking so damn long
Then once I get them I just need to plot out the holes on my bracket...
still need to finalise the thickness of the bracket... im thinking 3mm, but really need to engineer it properly
yeh its taking so damn long
#72
Former Sponsor
iTrader: (5)
Join Date: Aug 2005
Location: England
Posts: 2,236
Likes: 0
Received 0 Likes
on
0 Posts
23mm is better, less stress to the gasket. Please ensure the inside edge of the hole is smooth.
On second thought, if you are using a hole saw, it might over cut, Uuse 22 mm and open it up with a reamer or file, it is safer.
#75
ok bit of an update :
1) I have everything
2) Dog ate the water level sensor, so I need to get a new one DOH
3) The bracket design is done and being fabricated, hopefully I will have it ASAP
Once the bracket is done I can mount everything in the boot and run lines to the engine. Should I run the Meth lines UNDER the car? or inside the car? Does it matter?
1) I have everything
2) Dog ate the water level sensor, so I need to get a new one DOH
3) The bracket design is done and being fabricated, hopefully I will have it ASAP
Once the bracket is done I can mount everything in the boot and run lines to the engine. Should I run the Meth lines UNDER the car? or inside the car? Does it matter?