We all know the Alcohol I drink is in an aluminum can marked 12oz. But I can try anything

 

Since no one will make up there mind about meeting up i am gonna assume that we are gonna meet tomorrow!! if ou decide to meet tonight give me a call!!

Mike Perkins
850-305-0021

 

ROFLMAO .... no, I just wanted you to admit what you were counting down to.

 

$50 baseline dyno opportunity at Modern on 19-Feb. Check out this thread and PM bimmer if you're interested.
http://forums.utahscca.com/viewtopic.php?p=9526#9526

 

Yeah, tomorrow night, that's when I thought we planned it...and what if it's not a baseline? I'd like to see what the exhaust gave before I do the baseflash

 

nice cover up dumba$$.

 

got the headstuds in. no so bad. just hope it holds up! 3 of the bolts a pita but overall not so tough.

got half the shifter bushings in. ones under the hood. a 15 min job took almost two hours. i dropped one of the retaining pins. i looked all over for it with no luck. it phuckn pissed me off. finally gave up around 2am and just put a diff. pin in it. if wasn't so stubborn i would've just done that 5 mins after i couldn't find it.

oh also swapped out the 264's for the 280's. thanks ben!

 

ray did you do the head studs one by one???? hopefully you did.....

 

PM bimmer on the URSCCA site. I'm sure it will be fine.

 

When I did mine I did the same exact thing. Never did find it, apparently there is some kind of parts blackhole in the engine bay

 

Nice, I was hoping to get my car on the dyno before the flash to see what my exhaust gave me too. I have a friend who is setting one up for the end of March if anyone else is interested in doing one in a little while. I will hit that one to see what my car does after the flash.

 

one out, one in.... then the next one.

even tho i told you i hate short cuts, there was no way i was pulling the head to do this. i would rather taken the chance of a headgasket failure.

 

oh zach, btw when you do the drunkmans cams next sunday i'll just do your alignment while your doing the install, hows that sound?

 

haha, yeah blackhole is right. phucking hole! its the second part i lost to the hole on this car but the other piece was about 2"x8". still can't find it.

 

ok i was going to suggest that. i think i'm going to take the short cut route on my headstuds also!!!