I was looking all over trying to find a "better" way to utilize the factory fused connector, couldn't really find anything I liked that much so I decided to make a couple of these, less than 30$ to make, I didn't take pics of it mounted because i'm in the process of 100 projects, but I will take some installed in the next couple days if it warms up a bit.

This is the part I am using: Moroso 74144 Red Thru Panel Connector

This is the bracket, using the factory bolt where the old ground wire runs to mounted on the driver side strut tower area, clears Factory UICP, Muse UICP, and strut tower bar.





Pre gusset





Being painted

It looks clean, no wires need lengthened, just need to increase from 17' of 2 gauge to 18' of 2 gauge for extra room to route the wire.

 

Thought it would be a lot worse.
Awesome write up man.