haha dub v comin in!!! ive got a spare tire and jack to...interested?

 

You from pittsburgh kid? I went to high school with a kuzma
__________________
Buschur built

35r on corn

about 40 mins west of pitt....weirton wv actually!

and thanks for the welcomes! i know a little bit about pitt area

 

oh man....figures, wont be back in town till later tomorrow, hope they have another one down the road. I had so much fun at the one last year, this year would be better since I have good snows and not bald all-seasons..

Happy New Year Gents!

 

Anyone here own the silver 8 sitting @ denuzios in irwin??

Worst New Year ever, got food poisioning from old dailys lime juice
Been through 4 rolls of TP and puked atleast 40 times since 6 AM

 

Happy New Years People!

Few more weeks and I will have the Evo off the road....

Galant VR-4 will be the daily and I can give the Evo a much deserving going over/rest/light rebuild.

Anyone got a Evo MAF sensor laying around they wanna sell?

 

hey, some know me some dont, just saying happy new year to everyone.

 

Happy new year Jason

 

what up garrett, how was your new years

 

My gf was sick so we just hung out at the house. U do anything?

 

went to andreas families, got drunk, the usual new years. Whats up with the wife shes always getting sick......hopefully not in the mornings

 

Wutup jay u bad *** ***** fool hahahaha I'm sittin rite across from ya on a late nite move hahhaha

ya well everybody needs to get on the mustang n see where's they at ya man !!!!

 

Can I get some break pad recommendations from you seasoned gentlemen?

The Evo doesn't get driven a lot, it will see more street driving than drag, but it WILL see some 1320 time so I want something that will perform.

I'm thinking ebc red stuff, but I'd like recommendations first.

The car is high horsepower, I don't want a lot of dust, and I can't stand a lot of squeaking. Hope that narrows it down.

Thanks in advance guys

 

i'm not sure how fast you will be moving at the end of the 1/4, but the girodisc pads work pretty well (comparable to stock), they're fairly low dust, and economical. however with the 35r and korn you might need something a bit more aggressive to haul down your speed.

EvoDan has some race spec pads he is selling (nearly new), i'm not sure about the dust but he did mention the squeaking was a bit much for him on the street so they might not be what you're looking for either.

i have a habit of picking up used stock brake parts (pads and rotors) and that has done pretty well for me so far.

 

Wish I could remember what pads I had Mike put on when I bought the car. They have no brake noise and minimal brake dust. While I haven't had it on the 1/4 mile, I have run the car on the Beaver Run North Track and they have pretty good bite.

 

I like ebc pads, I use them on the del sol garrett, and even though I only ran low boost at prp, the car trapped 133, and they have a very short shutdown area, and they worked quite well. You'll probably be around the same trap speed I think anywhere from 130-140mph. Especially if you buy the s366 and we re tune it :-)