The DTC Disable thread (P1235, P1241, P1238, etc)
AWD, I got my OBD pin-8 logging working on the standalone just a couple days ago and it's well worth it (and much less work than the rear o2 tap, imo) now if only I could find a way to get that into EvoScan. I know most of the addresses transfer directly and you just change the "0x" to "23", but since the paramid=8 for the adc logging on standalone, I can't just put "8" in the request id when adding a new data item in EvoScan, right? Still new to this and oh-so lost.
Thanks chi-town
Evolved Member
Joined: Oct 2010
Posts: 2,447
Likes: 14
From: Australia
Newbie
Joined: May 2012
Posts: 17
Likes: 0
From: Houston
Just learning this software. Ive been getting the p1235 code as well, where do I paste these codes from tephra into my xml? Then is it done? or do I need to actually go into the tune and turn them off there? thanks for the help
the xml file is typically located in C:\Program Files\OpenECU\EcuFlashBeta\rommetadata\mitsubishi\ evo\
and yes, after you paste the snippet to your XML file and save, you have to open ECUFlash to change the values.
the xml file is just a list of addresses needed by ECUFlash to read your rom. you actually have to change values through ECUFlash.
and remember, always check to see if the before values match.
Is there no way to disable the P0420 catalyst efficiency code on a 2008 without taking out the rear O2 sensor, disabling the heater, and disabling all of the other codes that go along with that?
Just saw disabling the 0139 takes care of 0420 on the 2010+ years but does it work on 2008 too?
Just saw disabling the 0139 takes care of 0420 on the 2010+ years but does it work on 2008 too?
Last edited by TravisF; May 17, 2012 at 06:43 AM.
Doesn't the ECU Options #2 disable the heater though? If the sensor is still in the exhaust with no heater it will be destroyed
