Does it have casting number on the sides of the flange to the manifold?

 

Been trying to get a hold of Jared aka Jid and Eric on here, but I am waiting to hear back from Jared as he is closer.

 

What material is this exhaust housing made of?

 

 

Yuppers!

 

I have a feelin the 11.5 cm housing will use less waste gate due to more exhaust gas being vented through the turbine.. ring true to anyone else ? Might make a standard bellmouth a little better of a player here ..

 

Just by the appearance alone, it looks very similar to later model Evo III exhaust manifold which is a higher nickel cast.

Ramz, do you know if Jared is still doing seat lowering brackets? I want at least one pair of em.

 

Yeah I'm sure he is or still has a few laying around or can get them from his vendor. If I can get a hold of him next week after the 4th to get this ported I'll let you know. Prob will end up swinging by his house if i can.

 

Can you post the numbers for us??

 

Updates? Still porting ..?

 

Officially purchased one. Sending in my turbo to fp when it gets here

 

Yes. Still waiting to get the outlet ported. As soon as it's done it's game time. Glad to hear someone else take the plunge.

 

How is Ur inlet as far as gasket fitment? My mani doesn't have any room for porting but I was wondering how the new hotside was on the inlet side of things

 

It could use some porting further down in the inlet on the turbine side, but I will not be porting it. Its gasket matched pretty well though.

 

Good to hear, I honestly hope fp doesn't have a problem rebuilding my 16g with that aftermarket hotside. Robert sounded fairly openminded on the matter, but sounded skeptical of any gains in the same time... He was more interested in a quality aftermarket piece.. hence my cast iron vs steel question.