/cheer

 

sent a pm

 

i'm running an AEM 5 bar map sensor, the shop cut off the stock plug and soldered on athe one for the AEM map sensor. Now I need to pass emissions and dont have a plug lyning around to plug into the stock map sensor.... can someone help me? or point me in the right direction?


I'm missing the green plug that goes into the map sensor

 

you know what may have happened? I think I may have inadvertently flashed in a map that doesn't have the jdm map sensor coding in. ps I am also running no o2 with the rear o2 disabled and a 10 ohm resistor in the heater circuit

 

I found all the tables for your ROM. :-) I'll be writing instructions this evening.

 

I got mine from UltraRev. They had a good price. Its definitely a genuine Random Tech HFC. It took about three months before the first CEL appeared. I have read other threads where people with the Random Tech HFC also get a CEL. I installed a mechanical fix (spark-plug anti-foul extender) a few weeks ago. It seems to be helping.

 

Going to the PO now to mail about 12 sensors. :-)

 

Sweet cant wait for mine/ Hopefully it will be here by saturday

 

OK I poured over my tables and found 1 entry wrong in my MAP Check table, @ the 448 position I had 50 in place of 60 . oops If any thing returns I will let ya know.

 

Awesome, thanks for all the work mrfred. Wish I had my car here to test it out

 

My car is getting the p0401 code as well and idle is really bad! I don't know if this is the problem but I didn't change anything since. I am going to check it out right now.....

~Zach

 

Updated instructions for the '05 Evo 8 96940011 ROM are here:

https://www.evolutionm.net/forums/sh...d.php?t=259595

 

Sweet. Thanks mrfred.

How close is the 96940011 ROM to the earlier 96420008 ROM? Would it be difficult to find the addresses for the 96420008? I would try but I am weak in the area of dissassembly...

BTW- received the sensor. Thanks for the fast shippping!

 

Wow. I mailed it on Thursday. That was fast. Send your ROM to either email address I gave you, and I'll check it out.

 

You might want to change you "Other EVO 8 ROM's" to add the tables and change the scaling values to log boost correctly. I was reading it and it was a little missleading to me as plugging it in and going did work but threw a code, but it did not read the correct boost settings until you gave me the tables to update the scaling values. Then it seemed to work. Do you think you should put that in there?

~Zach