PATCH: CEL Flash on Loaded Knock
once we get this sorted we can get the mods to delete these posts 
Back on topic.....
When I use launch control I always get knock. If there is a way to correct this please tell me how. If not what configuration do you put into the knock controls to avoid this are of WOT from kicking up a CEL?
When I use launch control I always get knock. If there is a way to correct this please tell me how. If not what configuration do you put into the knock controls to avoid this are of WOT from kicking up a CEL?
ye just increase the load value for knock CEL
i dont think using the 2 step you would go over 160 load.
and it is not true knock, when you hit limiter it will show up as knock as well.
where have you set the knock to flash at 2 counts????
i dont think using the 2 step you would go over 160 load.
and it is not true knock, when you hit limiter it will show up as knock as well.
where have you set the knock to flash at 2 counts????
How can you confirm this is not true knock?
Might be knock occurring from the leaness when hitting limiter. At the rev limit the car just does a series of brief fuel cuts which is known to cause knock
Might be knock occurring from the leaness when hitting limiter. At the rev limit the car just does a series of brief fuel cuts which is known to cause knock
Try slowly ramping up to the limiter... if you slam the throttle it usually knocks, but if you slow ramp, you should be fine
I tried to test this patch for my rom, First I changed the endian to little and i got the correct millisec 3431ms..so I then changed it to 5000ms and changed the immobilzer code to mine by typing 0xffff (example) and I flashed my rom using 1.30 and the car started and died as if the immobilizer was wrong. But I looked at the address and it shows correct. So then I reflashed my backup rom and it started just fine. Any suggestions?