i have a an 06 evo

mods
intake full exhaust
turbo smart dual port bov
mbc
880cc injectors
walbro 255 fuel pump
buschur ported exhaust manifold
o2 dump
injen intercooler piping

i want to get it tuned on 25 26 psi how much power do you think the car will put out?

 

on a dynojet 350whp is possible

 

+1. you will be right in that area. get some cams though

 

when i do a bigger turbo i will get cams but for now i just want to look stock and sound stock as possible hopefully in the future do fp black also hks 272 cams

 

No cams and on a dynojet I'd say about 330

 

not hks, go with s2 or kelfords 272

 

X2. Just by switching from bc 272's to GSC S2's i gained 23whp and 15ft torque. The HKS are better than stock...but they wont yield the results of the kelfords or the S2's. Good luck with your build.

 

I had a customer go from 478 to 540 by changing from HKS 272 and arc air box to kelford 280/272 and cone filter.

 

thats because you squeeze the life out of setups mellon. Long time no talk. your barely on dont even get a hi how are you doing hi whats new with you

 

i've been a busy bee

 

Any suggestions for me to get to 400WHP???

Current Mods:
-APS Twin Vent BOV
-MBC
-Greddy Evo 2 TBE

Looking to buy:
-Buschur FMIC
-Buschur LICP
-GSC Cams
-Fuel Pump
-1200 CC Injectors

-E85
-Stock VIII Turbo

 

all you need is a good tune on e85 after those parts

 

Thanks Mellon, that's reassuring. Diirk from AWD will be doing the tuning. Hopefully one day I'll be able to run down bikes like you.

 

how much power and pressure this setup is capable safely

AEM EMS System for the EVO IX
AEM 3.5 bar map sensor
EVO 8/9 oil pump assy.
Mishimoto EVO 7-9 aluminum radiator
Exedy Hyper Twin Disk Metallic For Evo 8/9 HD Pressure Plate
Wet Sump Oil Pan AMS-EVO VII/VIII/IX
Power Enterprise 4G63 Balance Shaft Belt
Power Enterprise 4G63 Timing Belt
JE AMS Spec 2.0 Pistons with upgraded wrist pin and skirt coating (040 nore)
ARP main stud kit
ARP Head Studs
Clevite Rod Bearings
Clevite Main Bearing Set
Clevite Thrust Bearing Set
AMS Coil On Plug Ignition System Plug and Play
AMS EVO VIII Fuel System including Walbro pumps, Fuel Lab regulator, and Aeroquip lines
AMS Oil Pressure Sending Unit Remote Mount
Forced Performance EVO IX RED Turbocharger
80mm anti-surge inlet
Misc Auto Parts FP red Intstall kit
Manley88MM – 33.5 lb. Forged “Race Series” Crankshaft
Oil Cooler Kit AMS Evo VIII-IX Upgraded Oil Cooler Kit
GSC Beehive Spring Kit (includes new seats and titanium retainers)
Supertech 1mm over Intake Valves
Supertech 1mm over Inconel exhaust valves
Misc Auto Parts FIC easy tune fuel injector driver
HKS EVO VIII C... Adjustable cam gear for Evolution VIII
Race Balance Shaft AMS EVO Race Balance Shaft Eliminator Kit (NO CORE)
Fluidampr 2.0 4g63 EVO Mitsubishi-SFI (steel construction)
Cometic MITSU-LANCER EVO4-UP 86MM, .51" MLS
AMS EVO IX Black Radiator hoses
NGK Spark Plug for EVO 9 (Heat Range 9)
map adapter AMS 2g map sensor adapter
ManleyPerformance Pro Series 300M Alloy Connecting Rods
3/8" ARP 2000 cap fasteners
HKS intercooler type R
Custom 3" DP
HKS modified to test pipe
HKS catback
Tomei header
Megan O2
HKS 272 cams

Cant be exactly but some people can give me an estimate, so if this people could help me i appreciate.

Thanks, Rafael.

 

geez there's so many mods that have nothing to do with power that it's hard to read and I don't think you mentioned the octane, couldn't possibly guess